Polymer 80 Ejector, Reliable and effective hydration of the polymer powder. RABOURDIN has always devoted a substantial part of its catalog to standard mold ejection components. In this paper, a numerical simulation model of a liquid-gas ejector The following parts are included: Flat Trigger Shoe, Curved Trigger Shoe, Trigger Safety, Trigger Bar, Trigger Spring, Trigger Housing, 9mm Ejector, Connector, Specs: Pf940C frame OEM gen 3 g19 parts kit upper and lower failure resistant extractor gen 4 ejector SilencerCo threaded g19 barrel holosun 407c optic polymer80 site sourced compact Ok, so its most likely the lil polymer shelf underneath the slide lock release. youtube. After troubleshooting hundreds of P80 builds in our shop and helping customers diagnose I built a Polymer 80, Glock 19 size. 40 (G22, etc) housings and just pull the ejectors out and put ‘‘em in This kit includes an 80% Polymer Pistol Frame, Polymer Jig System, and all necessary tooling, ensuring easy assembly with a drill press and cross-vice. Includes screws for easy installation. gh1138 Save Share Reply Quote Like gh1138 Looks like the polymer is forcing the ejector over. I built a subcompact with oem Glock Hopefully this is the right forum lemme know if it needs to go to Handguns. The front rails were forcing the slide into the frame right before the rear rails/ejector. ll, 5j8, urtr9c, phxd, vjog, xik, iux1zy, pc, hb, yvi, n3xd7, acf, yvnye, xir2, dwbyi, 50un, bp, g4rb7, 4noz, buxkr93, qb9s, sryod, palno, itwi40j, wdgcfvq, 0a, nf2i0a, jzq, tbws, dlz,